Cases for Waveshare 3.2" display and compatible

Bottom

For use directly on top of Raspberry Pi4

The following is used when the display is placed directly on top of the Raspberry Pi4 (without TX-Pi HAT in between) since it has cutouts for the USB and Ethernet connectors of the Raspberry Pi4.

Bottom
Pi4_Display-Wanne.stl

For use directly on top of Raspberry Pi2 and Pi3

The following are used when the display is places directly on top of the Raspberry Pi2 or Pi3 (without TX-Pi HAT in between) since they have cutouts for the USB and Ethernet connectors of the Raspberry Pi Model 2 or 3.

The version with ribbon cable slot allows to route the camera ribbon cable from the pi through the display case. This is usually use in conjunction with version of the raspberry pi top case with camera and display slot.

The taller version is required for some older 3.2" V3 displays.

Regular bottom
display_v4_bottom.stl
Bottom with cable slot
display_v4_bottom_with_ribbon_slot.stl
Taller bottom
display32_v3_bottom.stl

For use with a HAT between the Pi and the Display

If a HAT is being used then the Ethernet and USB connectors do not protrude into the area of the display case. Thus the display case does not need any openings on the bottom in this case.

Bottom
Display-Wanne_ohne_Öffnungen.stl

Top

Top case for 3.2" display with three buttons:

3.2" top
display32_top.stl
buttons
buttons.stl

License

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.